Use a 2N7002 MOSFET,connect the source to ground and add separate DC voltage sources tothe gate and drain. Set the voltages to 2.5 V (gate) and 5 V(drain). Save an image of your circuit and include it in yourdocument. Perform a dc operating point (DC op pnt) simulation andpaste the output (as text) in your document. Confirm that theoperating point is at approximately VGS = 2.5 V and ID = 62 mA. [3marks]
b) Use your circuitand the “DC sweep” simulation option to generate the drain currentcharacteristics for this MOSFET. You should setup the drain voltageas the first source to sweep (from 0 V to 10 V at 1 mV intervals)and the gate voltage as the second (from 1 V to 3 V at 0.25 Vintervals). Run the simulation and include a plot of the draincurrent in your document (your plot should, of course, consist ofmultiple curves). NOTE USING LTspice
